DTC P0830: Clutch Pedal Switch A Circuit
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2010 Mercury Mountaineer, 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, and 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0830: CLUTCH PEDAL SWITCH A CIRCUIT
| Description: | The powertrain control module (PCM) monitors the clutch pedal position (CPP) bottom of travel (CPP-BT) switch only during the calibrated engine speed range (cranking speed range). This DTC sets when the CPP-BT switch does not indicate that the clutch is disengaged (clutch pedal pressed) when the engine is cranked. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | Verify the vehicle was not push-started with the clutch engaged. Check for aftermarket equipment such as remote starting devices which may bypass the CPP switch when cranking the engine. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | Refer to The Engine Does Not Crank in the appropriate STARTING SYSTEM article to diagnose the symptom no start, no crank. | ||