LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2289 (Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> DTC P0528: Fan Speed Sensor Circuit No Signal

DTC P0528: Fan Speed Sensor Circuit No Signal

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2010 Mercury Mountaineer, 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, and 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0528: FAN SPEED SENSOR CIRCUIT NO SIGNAL

Description:  The powertrain control module (PCM) uses the fan speed sensor (FSS) input to monitor the cooling fan clutch speed. If the indicated fan speed is lower than the calibrated value during the key on engine running (KOER) self-test, the DTC is set.
Possible Causes: 
  • FSS VPWR circuit open in the harness
  • FSS PWRGND circuit open in the harness
  • FSS circuit open in the harness
  • FSS circuit short to voltage or ground in the harness
  • Damaged FSS sensor
  • Damaged PCM
Diagnostic Aids:  Visually inspect the cooling fan clutch for damage or obstruction.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST HV .
scientia non olet · About LEMON Manuals