DTC P0030: Ho2S Heater Control Circuit (Bank 1, Sensor 1)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2010 Mercury Mountaineer, 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, and 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

DTC P0030: HO2S HEATER CONTROL CIRCUIT (BANK 1, SENSOR 1)

Description:	The powertrain control module (PCM) monitors the heater in the heated oxygen sensor (HO2S) for correct operation. The PCM controls the heater on/off duty cycle to maintain a calibrated temperature The PCM controls the heater on/off duty cycle to maintain a calibrated temperature. The test fails when the sensor does not warm up to the required temperature in a calibrated amount of time. The test also fails when the PCM is not able to maintain the required temperature after the sensor is warm.
Possible Causes:	Open UO2S circuit Open UO2SGREF circuit Open UO2SHTR circuit UO2SHTR circuit short to voltage Poor connections Damaged or corroded terminals Exhaust temperature significantly higher than expected Damaged HO2S
Diagnostic Aids:	Inspect the connectors for signs of damage, water ingress, or corrosion.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	-	GO to PINPOINT TEST DZ .	GO to PINPOINT TEST DZ .