DTC P0016: Crankshaft Position - Camshaft Position Correlation - Bank 1 Sensor A

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2010 Mercury Mountaineer, 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, and 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.

DTC P0016: CRANKSHAFT POSITION - CAMSHAFT POSITION CORRELATION - BANK 1 SENSOR A

Description:	The powertrain control module (PCM) monitors the variable camshaft timing (VCT) position for a misalignment between the camshaft and crankshaft. The test fails when the misalignment is 1 tooth or greater. This DTC can also be set due to VCT system concerns (oil contamination or VCT solenoid stuck).
Possible Causes:	Camshaft timing incorrectly set Continuous oil flow to the VCT piston chamber Erratic camshaft position due to low oil pressure Oil flow restriction in the oil passages or the VCT valve body VCT solenoid stuck in position Open or short in the VCT circuit Open VPWR circuit Camshaft advance mechanism binding (VCT unit) Damaged VCT phaser Damaged camshaft position (CMP) sensor Open or short in the CMP sensor circuits Radio frequency interference (RFI) interference
Diagnostic Aids:	These DTCs may be accompanied by other DTCs. Diagnose all camshaft position (CMP) sensor DTCs first. If no CMP sensor related DTCs are present, continue to follow diagnosis for the DTC. This DTC is a functional check of the VCT unit. Diagnose any base engine concerns related to the engine oil pressure or engine timing. Refer to Oil Pressure Test in the appropriate ENGINE SYSTEM - GENERAL INFORMATION article to check the engine oil pressure. Refer to the Timing Drive Components, in appropriate ENGINE article to check the engine timing and VCT phasers.
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	-	-	GO to PINPOINT TEST HK .