LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2288 (Engine Controls - Description & Operation (Except Diesel & Hybrid)) >> Engine Control Components >> Inertia Fuel Shut-Off (IFS) Switch

Inertia Fuel Shut-Off (IFS) Switch

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, 2010 Lincoln Town Car, and 2010 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.

The IFS switch is used in conjunction with the electric fuel pump. The purpose of the IFS switch is to shut off the fuel pump if a collision occurs. It consists of an inverted pendulum mass that is retained in a conical cone via a set of linear springs. When a sharp impact occurs, the pendulum shifts out of the conical cone, opens the circuit and shuts off the electric fuel pump. Once the switch is open, it must be manually reset before restarting the vehicle.

Fig 1: Typical IFS Switch
G06053886Courtesy of FORD MOTOR CO.