Fuel Injectors: Notes
WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, 2010 Lincoln Town Car, and 2010 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Do not apply battery positive (B+) voltage directly to the fuel injector electrical connector terminals. The solenoids may be damaged internally in a matter of seconds.
The fuel injector is a solenoid-operated valve that meters fuel flow to the engine. The fuel injector is opened and closed a constant number of times per crankshaft revolution. The amount of fuel is controlled by the length of time the fuel injector is held open.
The fuel injector is normally closed, and is operated by a 12-volt source from either the powertrain control module (PCM) power relay or fuel pump relay. The ground signal is controlled by the PCM.
The injector is the deposit resistant injector (DRI) type and does not have to be cleaned. Install a new fuel injector if the flow is checked and found to be out of specification.