LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2287 (Engine Controls - Diagnostic Methods (Except Diesel & Hybrid)) >> On Board System Readiness (OSR) Test >> Description

On Board System Readiness (OSR) Test: Description

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, 2010 Lincoln Town Car, and 2010 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.

All on board diagnostic (OBD) scan tools display the on board system readiness (OSR) test. The OSR displays the supported monitors on the vehicle and the status of all monitors (complete or not complete) at that time. Fuel, misfire, and comprehensive component monitors (CCMs) run continuously and always display a YES status. Clearing the continuous diagnostic trouble codes (DTCs) and resetting the emission monitors information in the powertrain control module (PCM), or resetting the keep alive memory (KAM) causes the non-continuous monitors to change to a NO status.

A detailed description of completing the OBD monitors is found, refer to ON BOARD DIAGNOSTIC (OBD) DRIVE CYCLE .

scientia non olet · About LEMON Manuals