LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2287 (Engine Controls - Diagnostic Methods (Except Diesel & Hybrid)) >> Flash Electrically Erasable Programmable Read Only Memory (EEPROM) >> Programming the VID Block for a Replacement PCM

Programming the VID Block for a Replacement PCM

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2010 Mercury Milan, 2010 Mercury Mariner, 2010 Mercury Grand Marquis, 2010 Lincoln Town Car, and 2010 Lincoln Navigator L. However, it is still accessible from the selected car via links, so may be relevant.

The VID block on a replacement PCM is blank and requires programming. There are two procedures available. The first is an automatic data transfer from the old PCM to the new PCM, the second is manual data entry into the new PCM.

Automatic data transfer is carried out if the old PCM is capable of communicating. This is done by using a scan tool to retrieve data from the old PCM before removing it from the vehicle. The stored data can be downloaded to the new PCM after it has been installed.

Carry out manual data entry if the old PCM is damaged or incapable of communicating. Remove and install a new PCM. Using a compatible scan tool, select and carry out the module/parameter programming, referring to the scan tool manufacturer's instruction manual. Make certain that all parameters are included. Failure to properly program tire size in revolutions per mile, (rev/mile equals 63,360 divided by the tire circumference in inches), axle ratio, 4x4/4x2, and/or MSOF/ESOF may result in DTCs P1635 and P1639. You may be instructed to contact the As-Built Data Center for the information needed to manually update the VID block with the scan tool. Contact the center only if the old PCM cannot be used or the data is corrupt. For Ford and Lincoln Mercury technicians, contact your National Hotline or the Professional Technician Society (PTS) web site for As-Built data listed under the Service Publications Index. Non-Ford technicians use the Motorcraft® web site at www.motorcraft.com. From the Motorcraft® home site, use the search function to find the Module Programming or As-Built Data.

For Ford and Lincoln Mercury technicians, check the Programmable Module Installation link on the PTS web site for quick Programmable Module data information by vehicle.

scientia non olet · About LEMON Manuals