P2195 - O2 Sensor Signal Biased/Stuck Lean - Bank 1, Sensor 1

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

P2195 - O2 SENSOR SIGNAL BIASED/STUCK LEAN - BANK 1, SENSOR 1

Description:	A heated oxygen sensor (HO2S) indicating lean at the end of a test is trying to correct for an over-rich condition. The test fails when the fuel control system no longer detects switching for a calibrated amount of time.
Possible Causes:	Electrical: Short to voltage in the harness or HO2S Water in the harness connector Open UO2SPC circuit Corrosion or incorrect harness connections Damaged universal HO2S Fuel System: Excessive fuel pressure Leaking/contaminated fuel injectors Leaking fuel pressure regulator Low fuel pressure or running out of fuel Vapor recovery system Intake Air System: Air leaks after the mass air flow (MAF) sensor Vacuum leaks Positive crankcase ventilation (PCV) system is leaking or the valve is stuck open Incorrectly seated engine oil dipstick Exhaust Gas Recirculation (EGR) System: Leaking gasket Stuck EGR valve Base Engine: Oil overfill Camshaft timing Cylinder compression Exhaust leaks before or near the HO2S(s)
Diagnostic Aids:
Application	Key On Engine Off	Key On Engine Running	Continuous Memory
All	GO to PINPOINT TEST H .