LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2283 (Engine Controls - Powertrain DTC Charts & Descriptions - (Hybrid)) >> DTC Diagnosis >> P1101 - Mass Air Flow (MAF) Sensor Out Of Self-Test Range

P1101 - Mass Air Flow (MAF) Sensor Out Of Self-Test Range

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
P1101 - MASS AIR FLOW (MAF) SENSOR OUT OF SELF-TEST RANGE

Description:  The MAF sensor circuit is monitored by the powertrain control module (PCM) for an out of range air flow (or voltage) input. If, during key on engine off (KOEO), the air flow voltage signal is greater than 0.27 volt the test fails. Likewise, if, during key on, engine running (KOER), the air flow voltage signal is not within 0.46 volt to 2.44 volts, the test fails.
Possible Causes: 
  • Low battery charge
  • MAF sensor partially connected
  • MAF sensor contamination
  • PWR GND open to the MAF sensor
  • MAF RTN circuit open to PCM
  • Damaged MAF sensor
Diagnostic Aids:  A MAF V PID reading greater than 0.27 volt (KOEO) or a MAF V PID reading outside the 0.46 volt to 2.44 volts range (KOER) indicates a concern.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST DC . GO to PINPOINT TEST DC . -