LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2280 (Engine Controls - Pinpoint Tests - (Hybrid)) >> Pinpoint Test TP: Traction Motor Overspeed >> Test Procedure

Test Procedure

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. TP1 CHECK FOR CORRECT TRACTION MOTOR RPM DURING THE ROAD TEST 
    NOTE: Refer to the table at the beginning of this pinpoint test for correct traction motor to vehicle speed correlations.
    • Clear the TCM DTCs.
    • Access the TCM and monitor the M_SPEED PID.
    • Access the TCM and monitor the VSS PID.
    • Road test the vehicle.
    • Record traction motor RPM at different vehicle speeds.

    Does the traction motor RPM correspond with the vehicle speed? 

    Yes No
    GO to  TP2. INSTALL a new transaxle assembly. REFER to the AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 .
  2. TP2 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTC) 

    Is DTC P0C2F present? 

    Yes No
    GO to PINPOINT TEST DP . Unable to duplicate or identify the concern at this time.
    RETURN to Symptom Charts to continue diagnosis.
scientia non olet · About LEMON Manuals