LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2272 (Steering Linkage) >> Removal And Installation >> Steering Linkage Damper >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering linkage damper-to-frame bracket nut and bolt.
    • To install, tighten to 80 Nm (59 lb-ft).
  2. Remove the steering linkage damper-to-drag link bracket nut and then remove the damper.
    • To install, tighten to 80 Nm (59 lb-ft).
    3. NOTE: If installing a new steering linkage damper-to-drag link bracket, make sure the bracket is properly positioned on the drag link before tightening the U-bolt nuts.
  3. To install, reverse the removal procedure.
  4. Rotate the steering wheel from stop to stop. Verify that the steering linkage damper is not bottoming out and that the steering linkage reaches its full travel when the steering wheel is turned from stop-to-stop.
scientia non olet · About LEMON Manuals