LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2255 (Electronic Engine Controls - Gasoline Engines) >> Removal And Installation >> Throttle Position (TP) Sensor - 5.4L >> Removal

Throttle Position (TP) Sensor - 5.4L: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
    2. NOTE: The clip must be pulled out before disconnecting the electrical connector.
  2. Disconnect the throttle position (TP) sensor electrical connector.
    3. CAUTION: Failure to remove the TP sensor screws in the following manner will result in damage to the screws. First loosen the screws 1-2 full turns using a hand tool and then use a suitable high speed driver to complete the removal.
  3. Remove and discard the 2 screws and the TP sensor.
scientia non olet · About LEMON Manuals