LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2252 (Automatic Transmission - 5R110W (TORQSHIFT(R))) >> In-Vehicle Servicing >> Shift Solenoids (SS) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Some solenoid body bolts and wire loom bolts will need to be removed in order to remove affected solenoids.
NOTE: The Line Pressure Control (LPC) solenoid is not serviced in the vehicle. The solenoid body will need to be removed to remove the LPC solenoid. For additional information, refer to Solenoid Body Assembly .
  1. Remove the transmission fluid pan, gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter .
  2. Disconnect the affected shift solenoid connector.
    3. Fig 1: Shift Solenoid Electrical Connectors
    GF0006825Courtesy of FORD MOTOR CO.
  3. Remove the affected shift solenoid.
    1. Remove the retaining E-clip.
    2. Remove the affected shift solenoid.
    4. Fig 2: Retaining E Clip And Shift Solenoid
    GF0006826Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals