LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2252 (Automatic Transmission - 5R110W (TORQSHIFT(R))) >> In-Vehicle Servicing >> Output Shaft Speed (OSS) Sensor >> Installation

Output Shaft Speed (OSS) Sensor: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the OSS sensor.
    1. Lubricate the O-ring and install the OSS sensor.
    2. Install the bolt.
      • Tighten to 9 Nm (80 lb-in).
    2. Fig 1: Output Shaft Speed (OSS) Sensor & Bolt
    GF0012403Courtesy of FORD MOTOR CO.
  2. Connect the OSS sensor connector.
    3. Fig 2: Identifying Output Shaft Speed (OSS) Sensor Electrical Connector
    G03889074Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals