LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2252 (Automatic Transmission - 5R110W (TORQSHIFT(R))) >> In-Vehicle Servicing >> Extension Housing Gasket >> Removal

Extension Housing Gasket: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles 

  1. Remove the driveshaft. For additional information, refer to DRIVESHAFT article.
  2. Remove the transmission insulator nuts.
    3. Fig 1: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
  3. Install a suitable transmission jack.
  4. Remove the transmission insulator bolts.
    5. Fig 2: Identifying Transmission Support Insulator Bolts
    G03889100Courtesy of FORD MOTOR CO.
  5. Remove the transmission insulator.
    1. Raise the transmission upward, from the transmission insulator.
    2. Remove the transmission insulator.
    6. Fig 3: Rear Transmission Mount
    GF0012408Courtesy of FORD MOTOR CO.
  6. Disconnect the output shaft speed (OSS) sensor electrical connector.
    7. Fig 4: Identifying Output Shaft Speed (OSS) Sensor Electrical Connector
    G03889074Courtesy of FORD MOTOR CO.

    Vehicles equipped with a fixed flange 

  7. Remove the output shaft flange.
    1. Remove and discard the output shaft flange bolt.
    2. Remove the output shaft flange.
    8. Fig 5: Identifying Output Shaft Flange And Bolt
    G04615854Courtesy of FORD MOTOR CO.
  8. Using the special tool, remove and discard the output shaft retaining nut.
    9. Fig 6: Identifying Output Shaft With Special Tool
    G04649634Courtesy of FORD MOTOR CO.
  9. Remove the bolts and the transmission extension housing.
    10. Fig 7: Locating Transmission Extension Housing Bolts
    G03889104Courtesy of FORD MOTOR CO.

    Vehicles not equipped with a fixed flange 

  10. Remove the bolts and the transmission extension housing.
    11. Fig 8: Identifying Bolts And Transmission Extension Housing
    GF0006822Courtesy of FORD MOTOR CO.

    All vehicles 

  11. Remove and discard the extension housing gasket.
    12. Fig 9: Locating Extension Housing Gasket
    G03889106Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals