LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2246 (Engine - 6.0L (99P E-Series) Diesel) >> In-Vehicle Servicing >> Engine Mount >> Removal

Engine Mount: Removal

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  3. Remove the cooling fan stator. For additional information, refer to ENGINE COOLING article.
  4. Remove the A/C compressor. For additional information, refer to CLIMATE CONTROL article.
  5. Remove the 2 power steering pump upper mounting bolts.
    6. Fig 1: Identifying Power Steering Pump Upper Mounting Bolts
    G03887251Courtesy of FORD MOTOR CO.
  6. Remove the LH fan stator stand-off.
    7. Fig 2: Identifying LH Fan Stator Stand-Off
    G03887252Courtesy of FORD MOTOR CO.
    NOTE: The front bolt will remain in the power steering pump.
  7. Remove the 2 bolts and position the power steering pump aside.
    8. Fig 3: Identifying Power Steering Pump Bolts
    G03887253Courtesy of FORD MOTOR CO.
  8. Remove the RH fan stator stand-off. Remove the bolt and position the cable aside.
    9. Fig 4: Identifying Cable and RH Fan Stator Stand-Off
    G03887257Courtesy of FORD MOTOR CO.
  9. Remove and discard the 2 exhaust flange nuts.
    10. Fig 5: Locating Nuts On Exhaust Downpipe
    GF0044559Courtesy of FORD MOTOR CO.
  10. Remove the 4 motor mount-to-crossmember nuts.
  11. Remove the upper motor mount studs.
    12. Fig 6: Upper Motor Mount Stud
    GF0011856Courtesy of FORD MOTOR CO.
  12. Loosen the 8 motor mount-to-motor mount plate bolts for each motor mount.
  13. Install the Adapter.
    14. Fig 7: Locating Engine Lift Adapters (303-D043-01)
    G04614140Courtesy of FORD MOTOR CO.
  14. Install the Engine Lifting Attachment and Heavy Duty Floor Crane.
    15. Fig 8: Raising Engine
    GF0011854Courtesy of FORD MOTOR CO.
    NOTE: Use care when raising the engine to avoid engine or body damage.
  15. Raise the engine.
  16. Support the engine with jackstands or other suitable devices.
  17. Remove the 8 motor mount-to-motor mount plate bolts and the motor mounts.
scientia non olet · About LEMON Manuals