LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2246 (Engine - 6.0L (99P E-Series) Diesel) >> In-Vehicle Servicing >> Crankshaft Front Seal >> Removal

Crankshaft Front Seal: Removal

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crankshaft pulley. For additional information, refer to Crankshaft Pulley .
  2. Punch 2 holes in the seal.
    3. Fig 1: Identifying Crankshaft Seal
    G03887244Courtesy of FORD MOTOR CO.
  3. Using the Oil Seal Remover, remove and discard the crankshaft seal.
    4. Fig 2: Removing Crankshaft Front Oil Seal
    GF0005709Courtesy of FORD MOTOR CO.
    NOTE: Production seals will not have a wear sleeve. If a service part has been installed, it will have a wear sleeve.
  4. If equipped, using the Crankshaft Front Wear Ring Remover, remove and discard the crankshaft pulley wear sleeve.
    5. Fig 3: Removing Crankshaft Pulley Wear Sleeve
    GF0005710Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals