Exhaust Manifold - RH: Removal

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
Remove the 4 exhaust Y-pipe flange nuts.

Fig 1: Locating Exhaust Manifold-To-Catalytic Converter Nuts

Courtesy of FORD MOTOR CO.

NOTE: It may be necessary to raise the exhaust Y-pipe for additional clearance when removing the exhaust manifold from the vehicle.

Remove the 10 nuts, the exhaust manifold and the exhaust manifold gasket.
- Discard the exhaust manifold gasket and the nuts.

Fig 2: Removing RH Exhaust Manifold

Courtesy of FORD MOTOR CO.

Remove and discard the 10 exhaust manifold studs.

Fig 3: Exhaust Manifold Studs

Courtesy of FORD MOTOR CO.

Clean and inspect the exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.