LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2243 (Engine - 6.8L) >> In-Vehicle Servicing >> Engine Oil Pressure (EOP) Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the engine oil pressure (EOP) switch electrical connector.
  3. Remove the EOP switch.
    • To install, tighten to 18 N.m (13 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals