LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2241 (Automatic Transmission - 4R70E/W, 4R75E/W) >> In-Vehicle Servicing >> Turbine Shaft Speed (TSS) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the turbine shaft speed (TSS) sensor electrical connector.
  3. Remove the TSS sensor bolt and sensor.
    • Remove the TSS sensor bolt.
    • Remove the TSS sensor.
  4. To install, reverse the removal procedure.
    • Tighten bolt to 11 Nm (8 lb-ft).
scientia non olet · About LEMON Manuals