Electronic Pressure Control (EPC) Solenoid: Installation
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install the EPC solenoid, bracket and bolt.
- Tighten to 10 Nm (89 lb-in).
- Inspect the lead frame for damage.
- Using the special tool, check all lead frame solenoid connections. The gauge should fit tightly and not fall out after being inserted.
- If the special tool passes through any lead frame connector pins or does not feel like it makes a good contact, install a new lead frame.
- Connect the molded lead frame to the solenoids.
- Connect the bulkhead inter-connector by pressing it in place by hand and fully seating the connector in place.
- Connect the EPC solenoid by pressing it in place by hand and fully seating the connector in place. Make sure that the terminals pass fully through the connector slots.
- Connect the TCC by pressing it in place by hand and fully seating the connector in place. Make sure that the terminals pass fully through the connector slots.
- Connect the shift solenoid SSA and SSB by pressing it in place by hand and fully seating the connector in place. Make sure that the terminals pass fully through the connector slots.
- Install the manual control lever. For additional information, refer to Manual Control Lever Shaft and Seal .
NOTE:
Lubricate the EPC solenoid O-rings with clean transmission fluid.