On-Board Diagnostics With Scan Tool
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For detailed instruction and other diagnostic methods using the scan tool, refer to the scan tool tester article and the appropriate Engine Performance article. These quick tests should be used to diagnose the PCM and should be carried out in order.
- Quick Test 1.0 - Visual Inspection
- Quick Test 2.0 - Set Up
- Quick Test 3.0 - Key On, Engine Off (KOEO)
- Quick Test 4.0 - Continuous Memory
- Quick Test 5.0 - Key On, Engine Running (KOER)
- Special Test Mode
- Wiggle Test
- Output Test Mode
- PCM Reset Mode
- Clearing DTCs
- OBD II Drive Cycle
- Other Scan Tool Features
For further information on other diagnostic testing features using the scan tool, refer to the appropriate Engine Performance article. Other diagnostic methods include the following:
- PID Access Mode
- Freeze Frame Data Access Mode
- Oxygen Sensor Monitor Mode