LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2239 (Fuel Charging And Controls - 4.6L (2V) And 5.4L (2V)) >> Removal And Installation >> Throttle Body - 5.4L >> Removal

Throttle Body - 5.4L: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The throttle body (TB) must be removed from the vehicle to be cleaned. Do not hold the throttle plate open with any object that could scratch the bore or plate while servicing or cleaning the TB.
  1. Remove the air cleaner assembly and air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
    2. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
  2. Disconnect the electronic throttle control electrical connector.
    3. NOTE: The red clip must be pulled out before disconnecting the electrical connector.
  3. Disconnect the throttle position (TP) sensor electrical connector.
  4. Remove the 4 bolts and the throttle body (TB).
    • Discard the TB gasket.
scientia non olet · About LEMON Manuals