LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2239 (Fuel Charging And Controls - 4.6L (2V) And 5.4L (2V)) >> Removal And Installation >> Throttle Body - 5.4L >> Installation

Throttle Body - 5.4L: Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new TB gasket, position the TB and tighten the 4 bolts in 2 stages.
    • Stage 1: Tighten to 9 Nm (80 lb-in).
    • Stage 2: Tighten an additional 90 degrees.
  2. Connect the TP sensor electrical connector.
    • Push back the red clip.
  3. Connect the electronic throttle control electrical connector.
    • Push back the red clip.
  4. Install the air cleaner assembly and air cleaner outlet tube. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING article.
scientia non olet · About LEMON Manuals