LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2238 (Fuel System - General Information) >> General Procedures >> Fuel Tank Draining

Fuel Tank Draining

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools

Illustration Tool Name Tool Number
GF0004199
100 Gallon Gasoline Hand Pump Storage Tanker 034-00007 or equivalent
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: When handling fuel, always observe fuel handling precautions and be prepared in the event of fuel spillage. Spilled fuel may be ignited by hot vehicle components or other ignition sources. Failure to follow these instructions may result in serious personal injury.
WARNING: Remove the fuel filler cap slowly. The fuel system may be under pressure. If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. Otherwise, fuel may spray out. Failure to follow these instructions may result in serious personal injury.
WARNING: Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this instruction may result in serious personal injury.
NOTE: Midship fuel tank shown, aft-of-axle tank similar.

All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Release the fuel system pressure. For additional information, refer to Fuel System Pressure Release - 4.6L, 5.4L and 6.8L  or Fuel System Pressure Release - 6.0L Diesel .
  3. If connected, disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  4. Release the fuel tank filler cap and position aside.
  5. NOTE: The fuel tank filler pipe cap and fuel door are removed from art for clarity.
  6. Insert a suitable fuel drain tube into the fuel tank filler pipe until it stops.
  7. Fig 1: Inserting Suitable Fuel Drain Tube Into Fuel Tank Filler Pipe Until It Stops
    GF0044818Courtesy of FORD MOTOR CO.
  8. Attach the fuel storage tanker to the fuel drain tube and remove as much fuel as possible from the fuel tank filler pipe.
  9. NOTE: Vehicle body removed from art for clarity.
  10. Remove the fuel tank filler pipe hose at the fuel tank-to-fuel tank filler pipe hose connection. Loosen the clamp and disconnect the fuel tank filler pipe hose.
  11. Fig 2: Locating Fuel Tank Filler Pipe Hose At Fuel Tank-To-Fuel Tank Filler Pipe Hose Connection
    GF0044819Courtesy of FORD MOTOR CO.

    Flex fuel midsize fuel tank 

    NOTE: The anti-siphon valve must be replaced after being removed.
  12. Using an appropriate tool, remove the anti-siphon valve.
    • Discard the anti-siphon valve.
  13. Fig 3: Removing Anti-Siphon Valve Using Appropriate Tool
    GF0044820Courtesy of FORD MOTOR CO.

    All vehicles 

    NOTE: Follow the operating instructions supplied by the equipment manufacturer.
  14. Insert the hose from the storage tanker and siphon the fuel through the fuel tank filler pipe opening in the fuel tank.