LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2235 (Engine Cooling) >> Removal And Installation >> Coolant Pump - 4.6L, 5.4L and 6.8L >> Removal

Coolant Pump - 4.6L, 5.4L and 6.8L: Removal

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fan and fan clutch. For additional information, refer to Cooling Fan - 4.6L, 5.4L and 6.8L .
  2. Loosen the 4 coolant pump pulley bolts.
  3. Rotate the tensioner clockwise and remove the accessory drive belt from the coolant pulley.
    4. Fig 1: Rotating Tensioner Clockwise
    GF0000336Courtesy of FORD MOTOR CO.
  4. Remove the 4 bolts and the coolant pump pulley.
  5. Remove the 4 coolant pump bolts and the coolant pump.
    • Discard the coolant pump O-ring seal.
    • Clean the sealing surfaces with metal surface prep. Follow the directions on the packaging.
scientia non olet · About LEMON Manuals