LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2223 (Wipers And Washers) >> Removal And Installation >> Wiper Mounting Arm and Pivot Shaft >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The windshield wiper mounting arm and pivot shaft is installed as an assembly.
  1. Remove the windshield wiper pivot arms. For additional information, refer to Wiper Pivot Arm .
  2. Remove the cowl top vent panels.
  3. Disconnect the windshield wiper mounting arm and pivot shaft.
    1. Remove the access cover from the dash panel.
    2. Remove the retaining clip.
    3. Disconnect the windshield wiper mounting arm and pivot shaft from the windshield wiper motor.
    4. Fig 1: Windshield Wiper Mounting Arm And Pivot Shaft, Access Cover & Retaining Clip
    GF0011489Courtesy of FORD MOTOR CO.
  4. Remove the windshield wiper mounting arm and pivot shaft.
    1. Remove the screws.
      • To install, tighten to 9 N.m (80 lb-in).
    2. Remove the windshield wiper mounting arm and pivot shaft.
    5. Fig 2: Windshield Wiper Mounting Arm And Pivot Shaft & Screws
    GF0011490Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals