LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2222 (Instrument Cluster (Ic), Message Center, And Warning Chimes) >> Removal And Installation >> Warning Indicator Bulb >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument cluster (IC). For additional information, refer to Instrument Cluster (IC) .
    2. NOTE: To remove a warning indicator bulb, rotate the bulb one quarter turn counterclockwise and lift it out from the instrument cluster.
  2. Remove the warning indicator bulb(s) in question.
    3. Fig 1: Locating Warning Indicator Bulbs
    GF0044877Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals