LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2222 (Instrument Cluster (Ic), Message Center, And Warning Chimes) >> Diagnostic Tests >> Instrument Cluster (IC) and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AH: DTC U0100 - Lost Communication With ECM/PCM >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

The instrument cluster (IC) sets DTC U0100 if data messages received from the PCM over the high speed controller area network (HS-CAN) are missing for greater than 5 seconds. For a complete list of all network messages, refer to MODULE COMMUNICATIONS NETWORK article.

NOTE: Once the instrument cluster (IC) sets DTC U0100, multiple gauges or indicators are likely to be inoperative in the cluster.

This pinpoint test is intended to diagnose the following:

scientia non olet · About LEMON Manuals