LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2219 (Seating) >> Removal And Installation >> Seat Armrest - Rear, Bench

Seat Armrest - Rear, Bench

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the armrest in the following sequence.
    1. Release the hook-and-loop at the rear of the armrest trim cover and access the armrest bolt.
    2. Remove the armrest bolt.
      • To install, tighten to 49 Nm (36 lb-ft).
    3. Remove the armrest.
    2. Fig 1: Armrest Trim Cover & Bolt
    GF0011331Courtesy of FORD MOTOR CO.
  2. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals