LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2210 (Glass, Frames And Mechanisms) >> General Procedures >> Window Glass Adjustment

Window Glass Adjustment

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
  2. Loosen, but do not remove, the window regulator bracket upper nuts.
    3. Fig 1: Window Regulator Bracket Upper Nuts
    GF0011362Courtesy of FORD MOTOR CO.
  3. Raise the front door window glass to the full up position.
    • Tighten the nuts to 12 Nm (9 lb-ft).
    4. Fig 2: Raising Window & Tightening Nuts
    GF0011363Courtesy of FORD MOTOR CO.
  4. Loosen, but do not remove, the rear glass channel bolt.
    5. Fig 3: Rear Glass Channel Bolt
    GF0011364Courtesy of FORD MOTOR CO.
  5. Partially lower the front door window glass to allow adjustment.
  6. Move the front door window glass to the rearward position.
    • Tighten the bolt to 12 Nm (9 lb-ft).
    7. Fig 4: Moving Front Door Window Glass Rearward
    GF0011365Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals