LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2208 (Handles, Locks, Latches And Entry Systems) >> General Procedures >> Auto lock and Horn Chirp Programming >> Enable Using the Ignition Lock Cylinder

Enable Using the Ignition Lock Cylinder

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The auto lock feature is not available on vehicles equipped with manual transmissions.
  1. Close all the doors.
  2. Confirm that the ignition switch is in the OFF position.
  3. Turn the ignition switch from OFF to ON.
    4. NOTE: Steps 4 through 8 must be carried out within 30 seconds.
  4. Press the door lock control switch UNLOCK button 3 times.
  5. Turn the ignition switch from ON to OFF.
  6. Press the door lock control switch UNLOCK button 3 times.
  7. Turn the ignition switch from OFF to ON.
  8. Press the door lock control switch UNLOCK button, then the LOCK button.
  9. Verify the horn chirps 1 time, followed by a long chirp of the horn. The auto lock/relock feature has been enabled.
  10. Turn the ignition switch to the OFF position to exit the enable/disable mode.
scientia non olet · About LEMON Manuals