LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2208 (Handles, Locks, Latches And Entry Systems) >> Diagnostic Tests >> Locks, Latches and Entry Systems - Module Controlled >> DTC Charts

DTC Charts

WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
VEHICLE SECURITY MODULE (VSM) DTC CHART

DTC Description Action to Take
B106E Solid State Driver Disabled Due to Short Circuit REPAIR all other DTCs. CLEAR the DTCs. REPEAT the self-test.
B106F Module Disabled Due to External Fault REPAIR all other DTCs. CLEAR the DTCs. REPEAT the self-test. If all other DTCs have been repaired and DTC B106F is still present, INSTALL a new VSM. REFER to MULTIFUNCTION ELECTRONIC MODULES article.
B1217 Horn Relay Coil Circuit Failure Go to Pinpoint Test G .
B1218 Horn Relay Coil Circuit Short to Vbatt Go to Pinpoint Test G .
B1300 Power Door Lock Circuit Failure CLEAR the DTCs. REPEAT the continuous and on-demand self-tests. If DTC B1300 is still present, INSTALL a new VSM. REFER to MULTIFUNCTION ELECTRONIC MODULES article. TEST the system for normal operation.
B1310 Power Door Unlock Circuit Failure CLEAR the DTCs. REPEAT the continuous and on-demand self-tests. If DTC B1310 is still present, INSTALL a new VSM. REFER to MULTIFUNCTION ELECTRONIC MODULES article. TEST the system for normal operation.
B1311 Power Door Unlock Circuit Open CLEAR the DTCs. REPEAT the continuous and on-demand self-tests. If DTC B1311 is still present, INSTALL a new VSM. REFER to MULTIFUNCTION ELECTRONIC MODULES article. TEST the system for normal operation.
B1396 Power Door Lock Circuit Short To Battery CLEAR the DTCs. REPEAT the continuous and on-demand self-tests. If DTC B1396 is still present, INSTALL a new VSM. REFER to MULTIFUNCTION ELECTRONIC MODULES article. TEST the system for normal operation.
B1982 Driver's Door Unlock Relay Circuit Failure CLEAR the DTCs. REPEAT the continuous and on-demand self-tests. If DTC B1982 is still present, INSTALL a new VSM. REFER to MULTIFUNCTION ELECTRONIC MODULES article. TEST the system for normal operation.
B1983 Driver's Door Unlock Relay Circuit Short to Battery CLEAR the DTCs. REPEAT the continuous and on-demand self-tests. If DTC B1983 is still present, INSTALL a new VSM. REFER to MULTIFUNCTION ELECTRONIC MODULES article. TEST the system for normal operation.
B2251 Parklamp Output Relay Driver Circuit Failure Go to Pinpoint Test G .
B2276 Less Than 2 Transmitters Programmed PROGRAM the remote transmitters. REFER to Remote Keyless Entry Transmitter Programming .
B2425 Remote Keyless Entry Out of Synchronization Go to Pinpoint Test F .
B2574 Drivers Door LOCK Switch Short to Ground Go to Pinpoint Test E .
B2575 Drivers Door UNLOCK Switch Short to Ground Go to Pinpoint Test E .
U0155 Lost Communication With Instrument Panel Cluster (IC) Control Module Go to Pinpoint Test I .
U2023 Fault Received From External Node U2023 is set when a module receives invalid network data from another module with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES article for a list of all DTCs.
All other DTCs - REFER to MULTIFUNCTION ELECTRONIC MODULES article.