Tire Pressure Monitoring System (TPMS) Sensor Activation
WARNING: This page is about a different car, the 2008 Ford RV Cutaway, 2008 Ford Econoline, 2008 Ford E450 Super Duty, and 2008 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Activation Tool, Tire Pressure Monitor | 204-363 |
NOTE:
The tire pressure sensors will go into a "sleep mode" after 30 minutes of inactivity to conserve battery power. The sensors do not transmit information while in sleep mode. It will be necessary to wake them up so they will transmit the latest tire pressure information.
- Turn the ignition switch to the ON position.
- Position the tire pressure monitor activation tool against the LF tire sidewall 180 degrees from the tire valve stem.
- Press the test button on the activation tool to activate the sensor, activate the sensor at least 2 times.
- Repeat Steps 2 and 3 for the remaining tires.
- If the tire pressure monitoring system (TPMS) indicator remains illuminated after adjusting and activating each sensor, refer to Symptom Chart - Tire Wear .
NOTE:
The activation tool will provide feedback in the form of a flashing green light and a beep sound for each successful response from a tire pressure sensor.