LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2188 (Manual Transmission External Controls) >> Removal And Installation >> Gearshift Lever >> Installation

Gearshift Lever: Installation

WARNING: This page is about a different car, the 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the gearshift lever.
  2. Connect the gearshift cables to the gearshift lever.
    3. Fig 1: Select Cable
    GF0025433Courtesy of FORD MOTOR CO.
    Fig 2: Gearshift Cable
    GF0025434Courtesy of FORD MOTOR CO.
    CAUTION: Make sure the clips are set completely within the cable adapter groove and fully seated.
  3. Install the 2 gearshift cable clips.
    4. Fig 3: Gearshift Cable Clips
    GF0025435Courtesy of FORD MOTOR CO.
  4. Install the 4 gearshift lever nuts.
    • Tighten to 25 Nm (18 lb-ft).
  5. Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION article.
  6. Install the floor console finish panel.
  7. Install the gearshift lever knob and boot assembly.
scientia non olet · About LEMON Manuals