LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2179 (Power Transfer Unit (PTU)) >> In-Vehicle Servicing >> Output Shaft Seal >> Removal

Output Shaft Seal: Removal

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure applies to vehicles equipped with automatic transaxles.
  1. Remove the Power Transfer Unit (PTU) rear output shaft flange. For additional information, refer to Output Flange .
  2. Remove the deflector.
  3. Using a suitable tool, remove the PTU output shaft oil seal.
scientia non olet · About LEMON Manuals