LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2156 (Engine Ignition - 2.3L) >> Removal And Installation >> Spark Plugs >> Removal

Spark Plugs: Removal

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Detach the 2 wire harness retainers from the ignition coil stud bolts.
  2. Disconnect the 4 ignition coil electrical connectors.
    3. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
  3. Remove the 4 stud bolts and the ignition coils.
    4. NOTE: Only use hand tools when removing or installing the spark plugs, or damage can occur to the cylinder head or spark plug.
    NOTE: Use compressed air to remove any foreign material in the spark plug well before removing the spark plugs.
  4. Remove the 4 spark plugs.
scientia non olet · About LEMON Manuals