In-Vehicle Servicing: Flywheel: Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Special bolts are used for installation. Do not use standard bolts.

Install the flywheel and tighten the bolts in the sequence shown in the following 3 stages:
- Stage 1: Tighten to 50 Nm (37 lb-ft).
- Stage 2: Tighten to 80 Nm (59 lb-ft).
- Stage 3: Tighten to 112 Nm (83 lb-ft).

Fig 1: Identifying Flexplate Bolts Tightening Sequence

Courtesy of FORD MOTOR CO.

Install the engine. For additional information, refer to Engine .