LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2153 (Engine - 3.0L (4V)) >> In-Vehicle Servicing >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the oil pump and install the bolts.
    • Tighten in the sequence shown to 10 Nm (89 lb-in).
    2. Fig 1: Identifying Tightening Sequence Of Oil Pump Bolts
    GF0017071Courtesy of FORD MOTOR CO.
  2. Install the oil pump screen and pickup tube. For additional information, refer to Engine Lubrication Components - Exploded View  and Oil Pump Screen and Pickup Tube .
  3. Install the timing drive components. For additional information, refer to Timing Drive Components .
scientia non olet · About LEMON Manuals