LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2146 (Engine Cooling - (Hybrid)) >> General Procedures >> Cooling System Flushing

Cooling System Flushing

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
Material

Item Specification
Motorcraft Premium Gold Engine Coolant with Bittering Agent (bittered in US only)
VC-7-B (US); CVC-7-A (Canada); or equivalent (yellow color)		 WSS-M97B51-A1
Premium Cooling System Flush
VC-1		 ESR-M14P7-A
NOTE: Dispose of old coolant and flushing water contaminated with antifreeze and cleaning chemicals in accordance with local, state or federal laws.
  1. Remove the radiator. For additional information, refer to Radiator .
    2. NOTE: Radiator internal pressure must not exceed 138 kPa (20 psi). Damage to the radiator can result.
  2. Backflush the radiator with the radiator in an upside-down position and a high-pressure hose in the lower hose location.
    3. NOTE: Thermostat and housing are serviced as an assembly.
  3. Remove the thermostat housing. For additional information, refer to Thermostat Housing .
  4. Position a high-pressure water hose into the engine through the engine return and backflush the engine.
scientia non olet · About LEMON Manuals