LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Wheel Alignment Specifications & Adjustment Procedures) >> Riding Height >> Adjustment Procedures (BLACKWOOD) >> Rear Ride Height Mechanical Resetting

Rear Ride Height Mechanical Resetting

WARNING: This page is about a different car, the 2003 Lincoln Blackwood, 2003 Ford Pickup, 2002 Lincoln Blackwood, and 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition key ON. Connect the scan tool to the Data Link Connector (DLC) and follow the directions. Select Air Suspension Module.
  2. Measure vehicle rear height (driver side) from the bottom of the jounce bumper metal housing to the jounce pad on the rear axle. See Figure .
  3. Using scan tool, adjust rear height to 3.6" (92 mm) by moving the rear of the vehicle down using the rear vent active command or by moving the rear of the vehicle up rear lift in rear height sensor PID.
  4. Loosen the ball stud nut on the rear air suspension height sensor-to-axle bracket and adjust it by moving it with the air suspension height sensor up or down until the voltage is 2.74-2.78 volt. See Figure . Tighten the ball stud nut to specification. See TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals