LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 214 (Wheel Alignment Specifications & Adjustment Procedures) >> Riding Height >> Adjustment Procedures (BLACKWOOD) >> Rear Ride Height Electronic Resetting

Rear Ride Height Electronic Resetting

WARNING: This page is about a different car, the 2003 Lincoln Blackwood, 2003 Ford Pickup, 2002 Lincoln Blackwood, and 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the scan tool to the Data Link Connector (DLC) and follow the directions. Select Air Suspension Module. Select the active commands menu "Save Calibration (Store Ride Height)." Trigger through the warning message. Monitor the rear height sensor PID.
    2. NOTE: Do not press the trigger after selecting REAR.
  2. Select REAR. Disconnect the rear height sensor link from the lower bracket ball stud. See Fig 1 . Slowly raise and lower the height sensor arm until the sensor voltage is 2.74-2.78 volts.
  3. Press the trigger to save ride height settings (turn from OFF to ON); this will calibrate the air suspension control module. Carry out the Rear Ride Height Mechanical Resetting. If the rear height mechanical resetting has been performed, clear DTCs and run On-Demand Self-Test.
    Fig 1: Adjusting Rear Ride Height (Blackwood)
    G00307355Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals