LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2136 (Information Center) >> Diagnostic Tests >> Instrument Cluster (IC), Message Center and Warning Chimes >> Principles of Operation >> Instrument Cluster (IC) >> Instrument Cluster (IC) Configuration

Instrument Cluster (IC) Configuration

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

The instrument cluster (IC) contains items that are configurable. While some configurable items are customer preference items, most items are configured at the end of the line production and only available for configuration using As-Built data. Refer to MODULE CONFIGURATION article for additional information on As-Built data and module configuration.

NOTE: When installing a new instrument cluster (IC), it is necessary to upload the module configuration to the scan tool. Following installation of the instrument cluster (IC), download the module configuration from the scan tool into the new instrument cluster (IC). Refer to MODULE CONFIGURATION article. It is also necessary to carry out a parameter reset procedure whenever a new instrument cluster (IC) or PCM is installed. Refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) - HYBRID article.

The configurable customer preference items are as follows:

scientia non olet · About LEMON Manuals