LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2136 (Information Center) >> Diagnostic Tests >> Instrument Cluster (IC), Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AS: The REGEN BRAKING DISABLED Message Is Inoperative/Always On >> Pinpoint Test As: The REGEN Braking Disabled Message Is Inoperative/Always On

Pinpoint Test As: The REGEN Braking Disabled Message Is Inoperative/Always On

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. AS1 RETRIEVE THE RECORDED DTCs FROM BOTH CONTINUOUS AND ON-DEMAND PCM SELF-TESTS 
    • Check the recorded PCM DTCs from the continuous and on-demand self-tests.
    • Are any PCM DTCs recorded? 
    1. YES  : REFER to the Introduction - Gasoline Engines article.
    2. NO  : Go to  AS2.
  2. AS2 RETRIEVE THE RECORDED DTCs FROM BOTH THE CONTINUOUS AND ON-DEMAND INSTRUMENT CLUSTER (IC) SELF-TESTS 
    • Check for recorded instrument cluster (IC) DTCs from the continuous and on-demand self-tests.
    • Are any instrument cluster (IC) DTCs recorded? 
    1. YES  : MULTIFUNCTION ELECTRONIC MODULES article.
    2. NO  : Go to  AS3.
  3. AS3 CHECK FOR CORRECT INSTRUMENT CLUSTER (IC) OPERATION 
    • Disconnect the instrument cluster (IC) connector.
    • Check for:
      • corrosion
      • damaged pins
      • pushed-out pins
    • Connect the instrument cluster (IC) connector and make sure it seats correctly.
    • Operate the system and determine if the concern is still present.
    • Is the concern still present? 
    1. YES  : INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation.
    2. NO  : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
scientia non olet · About LEMON Manuals