Pinpoint Test Aa: The Trailer Lamps Are On Continuously
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- AA1 CHECK FOR VOLTAGE AT THE TRAILER TOW CONNECTOR
- Key in OFF position.
- Disconnect: Trailer Tow C439
- Key in ON position.
- Measure the voltage the between trailer tow connector, harness side and ground as follows:
Trailer Tow Connector-Pin Circuit C439-2 CAT06 (YE) C439-1 CAT09 (GN) C439-3 CAT11 (BN) - Is any voltage present?
- YES : Go to AA2.
- NO : The vehicle is operating correctly. SEND the trailer to an authorized camper/trailer repair facility.
- AA2 CHECK THE SUSPECT RELAY
- Key in OFF position.
- Disconnect: Suspect Trailer Tow Relay
- Carry out the component test for the suspect trailer tow relay. Refer to appropriate COMPONENT TESTING article.
- Is the trailer tow relay OK?
- YES : REPAIR circuit CAT06 (YE) (LH turn), circuit CAT09 (GN) (RH turn), or circuit CAT11 (BN) (parking lamps) for a short to voltage. TEST the system for normal operation.
- NO : INSTALL a new turn trailer tow relay. TEST the system for normal operation.