LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2119 (Interior Trim And Ornamentation) >> Removal And Installation >> C-Pillar Trim Panel >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the safety belt D-ring bolt cover.
    2. Fig 1: Identifying D-Ring Bolt Cover
    GF0041713Courtesy of FORD MOTOR CO.
  2. Remove the safety belt bolt.
    • To install, tighten to 48 Nm (35 lb-ft).
    3. Fig 2: Identifying Safety Belt Bolt
    GF0041714Courtesy of FORD MOTOR CO.
  3. Remove the quarter trim panel. For additional information, refer to Quarter Trim Panel .
  4. Position the rear door weatherstrip aside.
  5. Remove the cover, the bolt and the C-pillar trim panel.
    • To install, tighten to 7 Nm (62 lb-in).
    6. Fig 3: Identifying C-Pillar Trim Panel Bolt
    GF0041715Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals