LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2119 (Interior Trim And Ornamentation) >> Removal And Installation >> A-Pillar Trim Panel >> Removal

A-Pillar Trim Panel: Removal

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the RH or LH front door weatherstrips aside.
  2. Pull inward on the upper A-pillar trim panel to release the A-pillar trim panel retaining clips.
    3. NOTE: Remove the A-pillar tether clip from the A-pillar trim panel. Do not remove the A-pillar tether clip from the A-pillar unless a new tether is being installed.
  3. Remove the A-pillar tether clip from the A-pillar trim panel.
    • Insert a flat-blade screwdriver into the base of the A-pillar tether clip.
    • Apply downward pressure on the screwdriver, sliding the A-pillar tether clip base downwards.
  4. Remove the A-pillar trim panel.
scientia non olet · About LEMON Manuals