License Plate Housing
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 425A22 | License plate housing |
| 2 | - | License plate housing nuts (4 required) |
| 3 | - | Liftgate |
- Remove the liftgate trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION article.
- Disconnect the license plate housing electrical connector.
- Remove the license plate housing retaining nuts (4 required).
- Release the license plate housing from the push clips and remove the license plate housing from the liftgate.
- To install, reverse the removal procedure.