LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2106 (Climate Control System - General Information And Diagnostics - (Hybrid)) >> Diagnostic Tests >> Climate Control System >> Electronic Automatic Temperature Control (EATC) Module - Diagnostic Methods >> Electronic Automatic Temperature Control (EATC) Module Cold Boot Process

Electronic Automatic Temperature Control (EATC) Module Cold Boot Process

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

The purpose of the cold boot process is to allow the EATC or EMTC module to reinitialize and calibrate the actuators. To carry out the cold boot process, follow the steps below.

  1. Turn the ignition switch to the OFF position.
  2. Disconnect the EATC module electrical connectors.
  3. Wait one minute.
  4. Connect the EATC module electrical connectors.
  5. Turn the ignition switch to the ON position.
  6. Select any position except OFF on the EATC module.

    7. The EATC module will now initialize and calibrate the actuators.

scientia non olet · About LEMON Manuals